200Tdi Discovery Conversion SS Front Exhaust Pipe 90 110
200Tdi Discovery Conversion SS Front Exhaust Pipe 90 110, SKU SPEX102SS
This conversion front pipe is for a Land Rover Discovery 200Tdi engine fitted in a LAND ROVER Defender 90 or 110. It has been designed to mate up to the standard Land Rover turbo diesel or 200 defender rear exhaust system.
We manufacture this conversion exhaust pipe in 2½” in 304 grade stainless steel in our engineering shop here in the UK
This specially made front exhaust pipe fits directly onto the Discovery 200Tdi turbo outlet designed in such a way to allow exhaust gases to flow through the system easier without restrictions unlike some imitations found on eBay.
We are the original designer & manufacturer of this exhaust pipe.
We then recommend fitting a standard turbo diesel exhaust or a Defender 200 tdi exhaust system as they are made differently internally than a normally aspirated or petrol system, this allows the exhaust gases to flow properly, so the engine doesn’t overheat and doesn’t cause back pressure. Our pipe is sleeved to suit either system. The front pipe/ intermediate pipe is cut into either of these systems to sleeve up to our conversion front pipe.
No modifications are required to the vehicle using this front pipe
The conversion front pipe comes with a gasket, manifold nuts, clamps and instructions.
Also available is a stainless steel rear exhaust system See related items below
For other conversion parts to fit this engine see related items below eg. intercooler kit, water pipe kit, air filter kit, pas pipe adaptor kit, electric fan kit
Click here for summary of installation Defender 90/110
IMAGE FOR ILLUSTRATIVE PURPOSES ONLY
Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance.
STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.
The exhaust is designed for the original Land Rover chassis. If a replacement chassis has been fitted there may be some differences in hangar brackets etc., causing fitting issues with the exhaust which is beyond our control.