SPCK224TADAPS3 Conversion Temp Sender Adaptor Land Rover S3
SPCK224TADAPS3 Conversion Temp Sender Adaptor Land Rover S3,
This adaptor is for 200 Tdi Discovery conversion in late LAND ROVER Series 2A and Series 3 with standard Land Rover Series temp gauge. Can be used on earlier models that have fitted the later temp gauge.
This is a metric fine thread adaptor and aftermarket Land Rover Lucas temperature sender 560794. Some 200Tdi engines have a coarse thread adaptor so please check before ordering as this will not fit.
This adaptor has been specially made with a longer thread, to adapt the engine to read the Late Land Rover S2A and series 3 temperature gauge.
This is also suitable for other conversions
INTERNAL 5/8″ UNF
EXTERNAL M16 x 1
The adaptor and temp sender are available separately, see related items below
If there are issues with the temp gauge after fitting, please check if the fuel gauge is working properly. The voltage regulator can be faulty. See related items for this part. Also please check all the earths are clean
We can also supply other kits for the Conversion Discovery 200Tdi into Series Land Rovers including full exhaust systems for long and short wheelbase models. Click here for summary of installation Series Models Conversion Parts 200Tdi Discovery in Series Land Rovers
See also SPCK238WS3 Conversion Water Pipe Kit using 200Tdi Discovery Intercooler radiator for 200 Tdi Discovery in Land Rover Series 2 to Series 3
This is also suitable for other conversions. with the fine thread
Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance.
STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.