Description
Conversion Exhaust System LR 2.5 Petrol – Series SWB LHD
Conversion Exhaust System LR 2.5 Petrol – Series SWB LHD, EXHS325PLHD
Conversion Exhaust System for Land Rover 2.5 Petrol Into Land Rover Series 2-Series 3 SWB Left Hand Drive with the 2.5Petrol exhaust manifold.
Manufactured in our engineering shop here in the UK out of 2″ 409 low grade stainless steel with mild steel flanges. It is then painted with heat resistant paint.
Kit comprises of
Front pipe,
Intermediate pipe,
Rear silencer, all in larger bore pipework and silencer designed for a bigger engine,
Also included are Intermediate clamps & tailpipe clamps, nut bolts and washers. Exhaust Mounting Rubber hanger kit.
This is for Left Hand Drive vehicles and exits behind the drivers side rear wheel. It follows the route of the standard exhaust.
This full conversion exhaust kit is designed to follow the same route as the standard exhaust system and to hang on the same chassis brackets as the standard exhaust and is designed for vehicles that have are fitted with standard leaf springs and the standard Series gearbox.
THIS SYSTEM IS MADE TO ORDER, IT MAY TAKE 7-10 DAYS.
IMAGE FOR ILLUSTRATIVE PURPOSES ONLY
Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance.
This conversion is designed for the original Land Rover chassis. If a replacement chassis has been fitted there may be some differences in crossmembers and brackets etc., causing fitting issues with some parts which is beyond our control.
STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.