200TDI Disco Full Conversion 300TDI Exhaust Kit-Land Rover 110
200TDI Disco Full Conversion 300TDI Exhaust Kit-Land Rover 110. SPCK224X110F –
Land Rover 110 with a Discovery 200 TDI engine & 200Tdi turbo fitted, Uses a 300TDI rear exhaust system Larger bore.
It is a larger bore than the Land Rover 2.5Petrol and 2.5 Normally aspirated and also the turbo diesel exhausts.
We recommend using the larger bore exhaust that suits the TDI engines so they don’t cause back pressure and overheating issues.
This is a full exhaust from the turbo outlet to the rear of the vehicle manufactured in ALUMINISED Mild Steel.
This kit consists of
Specially made Conversion front pipe (SPEX102)
Specially made Connector pipe SPEX160
Front silencer 300TDI
Rear Silencer & Tailpipe 300TDI
3 chassis mounting brackets, and fixings
3 link type mounting rubbers,
Instructions for fitting the front pipe and diagram of rear exhaust sections and brackets
This is an ALUMINISED MILD steel system painted with heat resistant paint.
The connector pipe may require cutting to suit and then slips inside the Conversion front pipe, See photos
See related Items Below for other conversion parts
IMAGE FOR ILLUSTRATIVE PURPOSES ONLY
Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance.
STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.
This full conversion exhaust kit designed for vehicles that have are fitted with standard suspension and the LT77 gearbox. The exhaust is designed for the original Land Rover chassis. If a replacement chassis has been fitted there may be some differences in crossmembers and brackets etc., causing fitting issues with the exhaust which is beyond our control.