Product Description
Land Rover 2.5Diesel Conversion Exhaust Kit Series SWB LHD
Land Rover 2.5Diesel Conversion Exhaust Kit Series SWB LHD, SKU EXHS325DLHD,
Conversion Exhaust Full System for Land Rover 2.5 Diesel fitted in Land Rover Series2, Series2A and Series 3 Left Hand Drive Models
Fits the following models
LAND ROVER Series 2 to Series 3 Short Wheel Base 88" Left Hand Drive, with Tailpipe exiting behind drivers side wheel (LHS)
Manufactured in our engineering shop here in the UK out of 2" 409 low grade stainless steel with mild steel flanges. It is then painted with heat resistant paint.
This exhaust kit comprise of
- Front pipe,
- Intermediate pipe,
- Rear silencer,
- Clamps, nut bolts and washers.
- Rubber hangar kit INCLUDED
All the pipework is in larger bore (2") pipework and the silencer is designed for a bigger engine
MADE TO ORDER PLEASE ALLOW 7-10 DAYS BEFORE DISPATCH
IMAGE FOR ILLUSTRATIVE PURPOSES ONLY
Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance.
STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.
This full conversion exhaust kit is designed to follow the same route as the standard exhaust system and to hang on the same chassis brackets as the standard exhaust and is designed for vehicles that have are fitted with standard leaf springs and the standard Series gearbox. The exhaust is designed for the original Land Rover chassis. If a replacement chassis has been fitted there may be some differences in hangar brackets etc., causing fitting issues with the exhaust which is beyond our control.
