Product Description
LandRover 2.5NA Diesel Stainless Conversion Exhaust Series LWB
LandRover 2.5NA Diesel Stainless Conversion Exhaust Series LWB, SKU
EXHS3LWB25DSS
Fits
LAND ROVER Series 1 to Series 3 4 cylinder 109" Long Wheel Base
Manufactured in 304 grade Stainless Steel
, 2" OD tube with Mild Steel Flanges
Kit comprise of
Front pipe,
Intermediate pipe,
Rear silencer and tailpipe, all in larger bore pipework and the silencer designed for a bigger engine,
Mild steel fitting kit with Stainless Steel nuts, bolts and washers.
Please note the intermediate pipe is designed to go through the hole in the chassis as per series 3 post 1974 chassis. This will need to be made if fitting to an earlier chassis (All replacement chassis are made with this hole)
Made to order 7-10 days
IMAGE FOR ILLUSTRATIVE PURPOSES ONLY
Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance.
STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.
This full conversion exhaust kit is designed to follow the same route as the standard exhaust system and to hang on the same chassis brackets as the standard exhaust and is designed for vehicles that have are fitted with standard leaf springs and the standard Series gearbox. We can supply a modified intermediate pipe if the LT77 is fitted. Please contact us for more information. The exhaust is designed for the original Land Rover chassis. If a replacement chassis has been fitted there may be some differences in hangar brackets etc., causing fitting issues with the exhaust which is beyond our control.
