EXHS325PLWB Conversion Exhaust Land Rover 2.5Petrol Series LWB

£506.00 (ex.VAT) £607.20 (inc.VAT)

Product Description

EXHS325PLWB Conversion Exhaust Land Rover 2.5Petrol Series LWB

EXHS325PLWB Conversion Exhaust Land Rover 2.5Petrol Series LWB.

Conversion Exhaust System for Land Rover 2.5 Petrol ina a Series LWB,

Fits LAND ROVER Series 2, Series 2A and Series 3 long wheel base 109" models.

Kit comprises of

front pipe,

intermediate pipe,

rear silencer,

all in larger bore pipework and silencer designed for a bigger engine, larger tailpipe bracket, clamps, nut bolts and washers. Rubber hangar kit included.

Please note the intermediate pipe is designed to go through the hole in the chassis as per series 3 post 1974 chassis. This will need to be made if fitting to an earlier chassis (All replacement chassis is made with this hole) This full conversion exhaust kit is designed to follow the same route as the standard exhaust system and to hang on the same chassis brackets as the standard exhaust and is designed for vehicles that have are fitted with standard leaf springs and the standard Series gearbox.  Made to order may take 7-10 days Manufactured in our engineering shop here in the UK out of 2" 409 low grade stainless steel with mild steel flanges. It is then painted with heat resistant paint. IMAGE FOR ILLUSTRATIVE PURPOSES ONLY Steve Parkers Limited have been designing and fitting land rover engine conversions for over 40 years. We have also been manufacturing in house, conversion exhausts for over 25 years. We try to supply a comprehensive set of conversion kits, so that when the job is finished it looks like a factory installation. They are supplied as separate kits to allow them to be bought individually or they can be added to the basket and all bought at once depending on your requirements. Many of our conversion parts are manufactured by a company with en iso 9002 approved and covered by liability insurance. This conversion is designed for the original Land Rover chassis. If a replacement chassis has been fitted there may be some differences in crossmembers and brackets etc., causing fitting issues with some parts which is beyond our control. STEVE PARKERS LIMITED have been designing and manufacturing conversion exhausts for over 25 years. Many of our exhausts are made in aluminised mild steel, 409 or 304 grade stainless steel. With mild steel flanges. Usually, they are designed for the engine requirements but also, we try to use the standard chassis brackets and rubber mountings. However, on some model’s other brackets may be required due to the many models of Land Rovers. We specialise in low volume bespoke exhausts.